Well, this is the first year that I've done a lot of canning. And I've been experimenting with different methods for preparation to find out which is the most time efficient while still giving a good quality end product.
The basic steps after getting the tomatoes are:
- Cleaning: including washing and paring out the stems and bad spots.
- Prep: Chopping vs. Blanching and peeling
- Seeding/removing peels
- Pre-Heating/and Canning
Whether you decide to steam can or pressure can, you should follow the instructions for your particular canner, and even read through the sections on canning Tomatoes in Putting Food By. There are websites with instructions from places like the North Dakota State University Extension Service. The main issue for tomatoes is that if you use a non-pressure method that the tomatoes have a pH of 4.6 or lower to prevent spoilage and botulism.
Cleaning is very important because botulism is a soil borne disease. I tried one batch after washing with a mild bleach rinse, and then a clear fresh water rinse. I didn't detect any taste difference at this time between the ones rinsed in bleach and those not. After a couple months, we'll see if there's a difference in flavor. But if you try the bleach rinse, I'd recommend do it only on whole, perfect skinned tomatoes. I feared that if the tomatoes had scarred skins or cuts that the bleach would get in the wounds and spoil the flavor. Also, I didn't soak the fresh tomatoes in this, I dunked them for a few seconds and then rinsed immediately with lots of water. Then I sniffed them until I couldn't smell any bleach. (Like I said, I was being all experimental.)
All of the sites say to use only good, un-bruised, un-damaged tomatoes. Well, we cut out the bad spots. And I risked it because of the next step.
Blanching and peeling looked like it would be a pain to do with so many tomatoes. So I didn't do it. I wasn't canning whole tomatoes or chopped tomatoes. I was making sauce. That means I was boiling the snot out of these tomatoes once, and bringing them to a boil a second time just before canning.
I tried three ways: Stock Pot; Crock Pot; and large Roasting Pan.
Stock Pot: my stock pot is 2 gal, which reduces to just about 1 gal when all done. There is a need to watch the stockpot more closely to prevent scorching the thicker the reduction gets.
Oven Roasting pan: Absolutely great for volume and ease. The oven was set to 320F and this did give us a tiny bit of caramelization. We got some overflow and filled the house with tomato/molasses aroma-which was nice to smell, but requires oven cleaning. Lesson: don't overfill the roaster.
Seeding/Peeling:Two methods used were an Italian tomato press and a Chinois (conical sieve). The tomatoes need to cool off to handling temperature before you press them.
The Italian Tomato Press worked fairly well on smaller volumes. It's intended for fresh tomatoes so the cooked tomatoes wouldn't be too hard for it. However, I had to cycle the remnants through at least three times to extract all the thick pulp. It did a great job keeping the seeds and skins out of the sauce. But it was a lot of cranking.
It is great for a small batch, but we were dealing with 30lbs or more per batch. Unfortunately the press has the expeller and the juice flow so close together it's hard to find pans that would handle the output without the crank getting in the way. Since the base is secured by suction, the table in this photo wouldn't work. And after washing the press a little olive oil on the suction cup keeps the rubber ready to adhere to a clean flat surface.
The Chinois worked great for the large batches. Grandma had one of these. We borrowed ours from our neighbor, Muriel. Now I need to scour the 2nd hand stores for a good quality old model. Very fast work of 30 lbs of tomatoes.
Pre-Heating/and Canning:After testing the acidity, adding just enough apple vinegar to bring it to 4.6 or below. A nice thick sauce:
So here's the 30'lbs of tomatoes in 6 quart jars, no peels/skins, no seeds. Ready for steam canning.